#Black and decker hedger how to#

Use a battery with the correct voltage on the hedge trimmer. To begin operating a Black and Decker hedge trimmer, insert the suitable battery for the device. Below is a step-by-step guide you can follow when using a Black and Decker hedge trimmer. The device has a straight trimmer blade that allows the user to make linear cuts along the tops and edges of the plant. They can be used in place of traditional garden shears if you are planning to trim plant habits instead of small branches. The Black and Decker hedge trimmer is a cordless device that you can use to trim overgrown bushes and shrubs in your garden. How Do You Use A Black And Decker Hedge Trimmer? Continue reading as we discuss the other essential information you need when using a Black and Decker hedge trimmer. Their cordless design makes them more convenient for overgrown hedges that stretch far from an outlet. The Black and Decker hedge trimmer uses batteries. Remove the battery and return the blade sheath.Release and lock the trigger button after using it.Sweep the trimmer blades at a 15-degree angle across the excess hedge growth.Keep one hand on the trigger and one hand on the bail handle while working.Keep pressing the trigger to keep the motor operating.Release the lock once the motor is running.Press down the trigger lock while squeezing the trigger.Let's dive right in!īelow is a step-by-step guide you can follow when using a Black and Decker hedge trimmer.

#Black and decker hedger how to#

You might have purchased one and are now wondering how to operate it at home.ĭon't worry because we have done the research to provide you with everything you need to know about using a Black and Decker hedge trimmer. Now re-assemble in reverse order and you should be good to go.Black And Decker hedge trimmers can be used to maintain your plant's growth habits. Slide the blades opposite of one another until the bottom blade moves back into place and is below the lip of the piece that holds them in. 9 times out of 10, the bottom blade will slip down past the bottom piece which holds them in place and the blades will not turn and you will get the electrical hum. Inspect the bottom of the motor where the blades oscillate. With the hedge trimmer laying down flat, remove the body. Next remove the 6 screws holding the body on with a flat screwdriver, and you may need a flashlight for some of them. Get a ratchet and socket screwdriver and remove the 6 nut & bolts that hold the blades together. Take out the 4 screws holding the handle on (phillips screwdriver) and slide the handle down over the blades.

Take out the 4 screws (flat screwdriver) holding the front blade guard, then remove blade guard. Now re-assemble in reverse order and you should be good to go.